WITURA CORPORATION SDN BHD
Office Address: 18-8-C, Gurney Tower, Persiaran Gurney, 10250 Penang, Malaysia. Tel: 604 - 228 9053 Fax: 604 – 228 9054
URL: http:// www.witura.com
Email: sales@witura.com
- 3 -
Installing the SIM Card
Proceed as follows:
a. Slide back the SIM door and lift it up
b. Slide the SIM card into the SIM door making sure that the clipped corner of the SIM card lines up with
the clipped corner of the SIM holder
c. Close the SIM door
d. Slide the SIM door to lock the SIM card in place
Setting up the Terminal
The Condition for Installation
The terminal asks for 220V AV power supply. It must be installed in the area where the GSM network can
cover. The strength of the signal can affect the quality of voice direct.
The Installation for Connect to Ordinary Telephone
1. Screw off the screws that are on the back of the terminal and pull out the corresponding circuit board.
Install SIM card for every circuit board and install the circuit board in place, and then tighten the
screws.
2. Install antenna. In order to ensure the quality of voice, antenna must be put beyond 1.5m from the
telephone and terminal.
3. One end of the telephone line connects to the “Phone” port of the terminal, the other end connects to
telephone.
4. “Power” port connects to power adapter that is connected to220V AC power supply. About 15—45
seconds later (the time is subject to local wireless network), the terminal will work in gear.
The sketch for connecting to ordinary telephone: each circuit board can be connected to one telephone
Draw your attention: Because there are many types of ordinary telephone and their electric parameters are
different .In order to avoid mutual disturbance between telephone and terminal and affect voice
quality .The distance between telephone and terminal is 1.5m at least.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern