Witura WT-1011RC IP 65 Bedienungsanleitung PDF herunterladen (Seite 7)

WT-1011RC IP65 GSM Remote Controller

And Alarm S

stem

WT-1011RC IP65 – USER MANUAL – Rev.1.6 – Technical Support: [email protected]

WITURA CORPORATION SDN BHD

Installation:

Installing the SIM Card

Note: Installing the SIM Card. Please be sure the initial 4 digit PIN code of SIM card is disabled.

This can be done by placing it in an unlocked Mobile phone and first checking if the SIM requested

any PIN code. If this is the case the PIN code can be disabled using the security settings on the

phone.

Proceed as follows

1. Slide back the SIM door and lift it up

2. Slide the SIM card into the SIM door making sure that the clipped corner of the SIM card lines

up with the clipped corner of the SIM holder

3. Close the SIM door

4. Slide the SIM door to lock the SIM card in place

Power Up the Device

Connect a 15 volt DC power supply to terminal 3 & 4 ensuring positive is connected to terminal

3, switch on the power supply, the power LED will lit indicating power is present, the network

LED indicator will initially flash quickly, once logged onto the network it will flash more slowly

approximately every 3 to 4 seconds

Note: You should install the WT-1011RC in a place where there is GSM signal coming from the

operator you want to use. Check it with a phone before proceeding with the installation. If you

need to install the device in a place with little signal, you may consider using an external antenna

that we may supply as an option to be purchased separately with 5m cable.

Input 15VDC Power

here

Power Switch

Insert SIM card

here

Install Antenna

here

Connect to Battery

Back-u

1 2 3 4 5 6 7 8 9 10 11 12 ... 28 29

Keine Kommentare

Witura WT-1011RC IP 65 Bedienungsanleitung Seite 7