Witura WT9002 Bedienungsanleitung PDF herunterladen (Seite 16)

WT-9002 IP65 User Manual

WT-9002 IP65 – USER MANUAL – Rev.2.0 – Technical Support: [email protected]

WITURA CORPORATION SDN BHD

Then input the current password 123456# (you should hear a short beep ~success)

Continue to enter new password 654321# for 2 times (another short beep if password

entered correctly)

If the change has not been successful you will hear 3 beeps and must re-enter

again.

The system only allows the 3 administrators to change the 6 digits password.

To change the password from the factory default 123456 to 654321 (Example) you can

just send the following SMS to the unit.

Example:

Sends a SMS Command: *PAWO#654321

If the change is successfully, the system will display “OK” on the screen and the

administrator will receive a reply message from the unit.

Returned Message:

PAWO-OK

It is possible to change any of the administrator numbers using the following prompts on

the keypad and making the following three calls to the unit assuming the following 3

numbers are to be changed as.

Example:

Change TEL1 to 4444444444

Change TEL2 to 5555555555

Change TEL3 to 6666666666

Once the call has connected… (With a short beep ~ prompt the administrator to enter

password, the initial set up password is 123456 by default)

4.6 CHANGING THE PASSWORD VIA SMS

4.7 CHANGING THE ADMINISTRATOR NUMBERS VIA VOICE

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 46 47

Keine Kommentare

Witura WT9002 Bedienungsanleitung Seite 16